FaciliPro™ Monostar™ - Phazer™

Features & Benefits:

Fewer coats: two coat scrub and recoat and three-four coat full strip application - Time and labor savings versus conventional systems

Superior leveling with string mop - Excellent application appearance

Medium to low burnishing frequency - Great option for most customers

Uses/Solutions:

On hallways and high traffic areas

Can be applied over any conventional resilient finish/sealer and on resilient and other type of natural and man made floors

Can be used for two-coat scrub and re-coat and three-coat full strip applications

Effective Against/On:

Designed for medium to low maintenance routines

Application Method:

• FACILIPRO Phazer Ultra High Solids Floor Finish may be applied in either thin, medium, or heavy coats, depending on the application technique.
  • Average coverage 2000 sq ft. / US gal. (196 m²/3.78 L).
• The average dry time to walk will be 25-40 minutes; allow approximately 40 minutes between coats.

Directions for Use:

Set-up

• Pre-rinse the applicator pad; wring out and center the pad onto the applicator head.
• Place a bag of product into the pack with the bag spout at the bottom of the pack and facing out. Lock the spout into position. Close the cover and secure the locking strap.
• Attach the delivery tube by rotating the tube connector onto the spout and hand tighten. Put on the pack and adjust the straps.

Application Method

• Plan your route to maintain a wet leading edge. Work in sections.
• Depress the lever on the applicator handle to dispense product as needed.
• Apply thick coats at approximately 1000 sq .ft / U.S. gallon - or twice as heavy as conventional finish.
• Work the applicator pad through a small puddle of product to pre-load the pad.
• Outline the first section and fill in using an overlapping figure-8 pattern; overlap the outline.
• Start slowly and build speed over time to avoid ridges, splashing and missed areas.
• Remove using any Ecolab floor finish stripper. Follow label directions.

Clean-up

• Remove the tube connector from the spout. Attach the tethered adapter. Activate the handle lever and hold the connector under running water. Rinse out the system thoroughly.
• Rinse the exterior of the bag spout.
• Immerse the applicator pad in water (do not allow the finish to dry on the pad). Rinse well under running water. Wring and hang the pad to dry.